1、確認現場所接電源與電動扳手銘牌是否相符。是否接有漏電保護器。
1. Confirm whether the power connected to the site is consistent with the nameplate of the electric wrench. Whether leakage protector is connected.
2、根據螺帽大小選擇匹配的套筒，并妥善安裝。
2. Select the matching sleeve according to the size of the nut and install it properly.
3、在送電前確認電動扳手上開關斷開狀態，否則插頭插入電源插座時電動扳手將出其不意地立刻轉動，從而可能招致人員傷害危險。
3. Confirm that the switch on the electric wrench is disconnected before power transmission, otherwise, the electric wrench will turn unexpectedly and immediately when the plug is inserted into the power socket, which may cause personal injury.
4、若作業場所在遠離電源的地點，需延伸線纜時，應使用容量足夠，安裝合格的延伸線纜。延伸線纜如通過人行過道應高架或做好防止線纜被碾壓損壞的措施。
4. If the work place is far away from the power supply and the cable needs to be extended, the extension cable with sufficient capacity and qualified installation shall be used. If the extension cable passes through the sidewalk, it shall be elevated or measures shall be taken to prevent the cable from being crushed and damaged.
5、盡可能在使用時找好反向力距支靠點，以防反作用力傷人。
5. Try to find the reverse force distance support point during use to prevent the reaction force from injuring people.
6、使用時發現電動機碳火花異常時，應立即停止工作，進行檢查處理，排除故障。此外碳刷需要保持清潔干凈。
6. When the carbon spark of the motor is found to be abnormal during use, the work shall be stopped immediately, and the troubleshooting shall be conducted. In addition, the carbon brush needs to be kept clean.
7、站在梯子上工作或高處作業應做好高處墜落措施，梯子應有地面人員扶持
7. Measures for falling from height shall be taken when working on the ladder or working at height. The ladder shall be supported by ground personnel
The above is the detailed introduction of the electric torsion shear wrench for you. I hope it will be helpful to you. If you have any questions, please contact us. We will provide you with services with an attitude of http://www.sxmingxi33.cn
