扭矩扳手的更小扭矩范圍為5N.m，扭矩范圍為225N.m.液壓扭矩扳手3360注意事項液壓扳手的扭矩不是從0開始，也是由液壓扳手泵決定的。因為液壓扳手泵是二級泵還是三級泵，無論是齒輪泵還是柱塞泵，在壓力低流量大的時候，溢流大，壓力不穩定，扳手的輸出扭矩也不穩定。扭矩的精確測量從第二階段開始。第二級流量比低壓流量小得多。
The minimum torque range of the torque wrench is 5N. m, and the maximum torque range is 225N. m. Hydraulic torque wrench 3360 Precautions The torque of the hydraulic wrench does not start from 0, but is also determined by the hydraulic wrench pump. Because the hydraulic wrench pump is a two-stage pump or a three-stage pump, whether it is a gear pump or a plunger pump, when the pressure is low and the flow is large, the overflow is large, the pressure is unstable, and the output torque of the wrench is unstable. The accurate measurement of torque starts from the second stage. The second stage flow is much smaller than the low pressure flow.
沒有溢流和穩定性，可以精確控制扭矩。使用扭矩扳手3360時的注意事項不要使用預設的扭矩扳手來拆卸螺栓或螺母。禁止將套筒延伸臂安裝在扭矩扳手的端部，以防損壞扭矩扳手。根據需要調節所需扭矩，使用前確保調節機構已鎖定。
No overflow and stability, torque can be accurately controlled. Precautions when using the torque wrench 3360 Do not use the preset torque wrench to remove the bolt or nut. Do not install the socket extension arm on the end of the torque wrench to prevent damage to the torque wrench. Adjust the required torque as required and ensure that the adjusting mechanism is locked before use.
The above is a detailed introduction to the special wrench for torsional shear bolts. I hope it will be helpful to you. If you have any questions, please contact us. We will provide you with professional services http://www.sxmingxi33.cn
